Steps on EEPROM Chip Reading/Writing Via Xtool KC501
First of all, connect USD with PC
2.Check the light Red Light on: standby mode Green Light on: Data Transmission
E.g.: Atmel AT24C01A Chip Read/Write
3.Then, Open the chip lock socket lever and put into the chip according align with the pin.
4.Open software in PC, “Successfully Connected” will be shown:
E.g.: EEPROM – Atmel – AT24C01A Chip Read/Write
5.Write data into the chip
6.Can Read/Write/Erase 7 kind of Freescale’s MCU
7.Connect chip In terms with below diagram, have it connect with KC501.
8.Same type of chip may have different pin number, e.g. 80PIN, 112PIN,144PIN…
Supported ECU:
Warning: Please turn off the power when connecting the ECU, turn on 12V power after its connected. Read/Write MCU could be a reference when doing Read/Write the chip here.
